Directions/Instructions
To Sanitize and Disinfect: Pre-clean surface., Hold can upright 6" to 8" from surface., Spray 3 to 4 seconds until covered with mist., To sanitize:, Surfaces must remain wet for 10 seconds then allow to air dry., To disinfect:, Surfaces must remain wet for 3 minutes then allow to air dry. To Control and Prevent Mold and Mildew: Apply to pre-cleaned surface, Allow to remain wet for 3 minutes, Let air dry, Repeat applications in weekly intervals or when mold and mildew growth appears Use on hard, non-porous surfaces Pre-clean surfaces prior to use., Hold can upright 6 to 8 inches from surface., Spray 3 to 4 seconds until covered with mist., Rinse toys and food contact surfaces with potable water after use. To disinfect: Surfaces must remain wet for 3 minutes then allow to air dry., For Norovirus surfaces must remain wet for 10 minutes then allow to air dry To sanitize: Surfaces must remain wet for 10 seconds then allow to air dry. To control and prevent mold and mildew: Apply to pre-cleaned surface., Allow to remain wet for 3 minutes., Let air dry., Repeat applications in weekly intervals or when mold and mildew growth appears. To deodorize: Spray on surfaces as needed. To spot sanitize soft surfaces: Spray until fabric is wet., DO NOT SATURATE., Fabric must remain wet for 30 seconds., Let air dry., For difficult odors, repeat application. 1 TO SANITIZE AND DISINFECT:Pre-clean surface.Hold can upright 6" to 8" from surface.Spray 3 to 4 seconds until covered with mist.To sanitize:Surfaces must remain wet for 10 seconds then allow to air dry.To disinfect:Surfaces must remain wet for 3 minutes then allow to air dry.Use on hard, non-porous surfacesPre-clean surfaces prior to use.Hold can upright 6 to 8 inches from surface.Spray 3 to 4 seconds until covered with mist.Rinse toys and food contact surfaces with potable water after use.To disinfect:Surfaces must remain wet for 3 minutes then allow to air dry.For Norovirus surfaces must remain wet for 10 minutes then allow to air dryTo sanitize:Surfaces must remain wet for 10 seconds then allow to air dry.To control and prevent mold and mildew:Apply to pre-cleaned surface.Allow to remain wet for 3 minutes.Let air dry.Repeat applications in weekly intervals or when mold and mildew growth appears.To deodorize:Spray on surfaces as needed.To spot sanitize soft surfaces:Spray until fabric is wet.DO NOT SATURATE.Fabric must remain wet for 30 seconds.Let air dry.For difficult odors, repeat application. 1
